Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
IntroductionThis document describes typical steps needed to replace fabric borders in an SDA fabric with redundant border nodes. This procedure is for replacing an existing border device with an unlike device (a different product or platform, such a...
Overview
The devices under Catalyst Center inventory can have multiple SMU, subpackage or APSP. One can have same site with multiple same type of devices, but they might not have same packages. For example - eWLC package is a pre-requisite for APSP...
William, I have recreated this and it worked fine for me. I was able to successfully ssh to the bluecoat device IP - 192.168.199.2 from the Admin device. I hope you have the routing set correctly.Did you change the ACL and the source list to 111 and ...
Durga,The command 'boot system tftp ios_image ip address' would help boot the router from the IOS on a tftp server only if there is a working IOS image as the first file in the flash. You can not boot the router from an IOS on the tftp server without...
Hi Navinder,Please post the exact command and the error that you are getting.http://www.cisco.com/en/US/docs/ios/interface/configuration/guide/ir_halfport_pri_net_mod.html#wp1027188Would it be possible to attach 'show run' as well? You may mask any I...
