Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're currently running a Cisco ACS 5.3.0.40 VM appliance and using this to authenticate wireless clients from a Cisco 5508 WLAN setup. I've setup a Service Selection rule to match RADIUS Protocol and a Compound Condition where RADIUS-IETF is lookin...
Hello all,I'm trying to connect up a Cisco 1921 with a VWIC2-1MFT-T1/E1 card to a 56K Frame-Relay circuit and I'm having problems seeing the controller going up. The dmarc looks to be an Adtran T-200 IDSL OCU-R (PDF: http://www.adtran.com/pub/Libra...
I'm working with a 5548 remotely and need to make some routing changes. When working with remote switches and routers in the past, I've always included a reload with a delay just incase I lock myself out with the commands that I will be issuing. I ...
I was just curious if there are any performance benefits of using multiple network objects on multiple rules vs consolidating them into fewer rules by grouping them? For example, I have about 10 lines of NAT exempt rules from the same source to mult...
PRTG offers a free version that will allow you to monitor up to 10 sensors which should cover the bandwidth monitoring and netflow.http://www.paessler.com/
If the server you're downloading from only have a 1.5Mbps pipe to their ISP, that'll be the fastest it'll be able to serve your request no matter if you have a 2 Mbps pipe or 20 Mbps pipe
