HiI have a mikrotik ccr1072-1G-8S+ with a S+DA0001 going to a CISCO 3750X installed with a C3KX-NM-10G module. I cannot get this to work though. The mikrotik detects the SFP+ connected to it fine, but the cisco wont recognise the SFP+ module connecte...
Hi
We have a 2960G connected to a server. Both have negotiated to 1G/FULL. I am having the server team investigating the server logs for errors, but what we are seeing on the switch is a whole lot of output errors, but NO output drops. Hardware: ...
I have a CISCO 897 thats used on a fairly user heavy site. They would suddenly stop being able to NAT traffic outbound and generally nothing is able to transit the router outbound to the internet with NAT. Stats are:
ROUTER#sh ip nat statTotal act...
Hi
I have a MPLS network (not yet L3VPN) running over public internet. The basic network is like this:
SERVER-------PE1-----P1-------------P2-----PE2-------SERVER
Between P1 and P2 there is the public internet and to connect the two P routers I hav...
Hi
I have a private WAN. We would like to do directed outbound NATing on our CPE to the internet, however would like to keep LAN to LAN networks fully accessible to the private to private addresses
One site (SITE A) has a server in it hosting sever...
HiI have exactly the same problem! Did you ever resolve this?Also I have to ask, the tunnel interface IP addresses, how do you know what to set this as? Where is this documented? I have the same CISCO 2901 with 2 VPN's to two different AZURE insta...
Hi
Results of the test:
SWITCH# test cable-diagnostics tdr interface g0/41TDR test started on interface Gi0/41A TDR test can take a few seconds to run on an interfaceUse 'show cable-diagnostics tdr' to read the TDR results.SWITCH#show cable-diagnosti...
Hi
I have run the TDR and this has come back with good results - no errors. I have just updated the IOS to (C2960-LANBASEK9-M), Version 15.0(2)SE6, and the errors are still there. Any other ideas? This is impacting performance for a us a lot.