Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,There're some different kind of certificates in the WLC, I'm a bit confused. Is there any document give them a summarization? For example, can some of the certs share the same cert?1. HTTPS has a SSL cert(CN=169.254.1.1)2. Web-Auth has a SSL c...
Hi All, Does anybody know if there's any limitations or bugs to use WLC's service interface IP when add WLC into WCS?Another question is I remember there's a post previously says that there are a bug regarding to ARP if the WLC not using LAG but conn...
Hi all, can somebody tell me if 1522 can be configured to do ethernet bridging and service wireless client in the same time? My customer has a mesh network comprised of 1522, previously the MAP only service wireless client, not ethernet connection, e...
I have a quick question about UDP 16667, it is said in configuration guide that:“IPSec encryption can also be configured for the inter-controller mobility messages, in which case port 16667 is used.”My question is how to configure IPSec to support it...
Hi, has anybody seen the same issue previously:1. WiSM 5.2.193/AP1252/ACS5.0/WINDOWS7 laptop/EAP-TLS authentication for the WLAN2. Each time the client try to join the WLAN failed, there's no Radius authentication report for this failed connection in...
Since this has not been fully tested for VPC on Nexus, I would suggest not to do it if possible. There are some cases working with N7K by enable vPC peer gateway function, there are some bugs such as CSCtc01947 which had been fixed, however you may ...
Glad to hear the problem had been resolved.Cisco's documents sometimes are bit confusing, it's better to have a try. So the "maybe not" refers to the 5500+Non-LAG situation.
Don't know where you got the message from Cisco that they may or may not in the same vlan, however In the page 3-7 of WLC configuration guide 7.0, it clearly says that:For Cisco 5500 Series Controllers in a non-link-aggregation (non-LAG) configuratio...
For Cisco 5500 Series Controllers in a non-link-aggregation (non-LAG) configuration, the management interface must be on a different VLAN than any dynamic AP-manager interface. Otherwise, the management interface cannot fail over to the port that the...
