Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Have come across a very unusual problem,I have a device that constantly rejects IP address from a particular vlan. now, the issue could be in either device or network. Leaving aside the device (assuming the device might as well need a new NIC)...
Gday People,Got a mind-boggling issue with a Gig0/2 port on Cat2960 48TTL, the port seens dud. I cant enable it, its not shutdown either. However, when I restart the switch, on CNA, i can see the interface flash amber (as all ports do when restarted)...
Hi All,what are the precautions when configuring channel-group between cisco3560 and cisco2960.i have created a port-channel interface 10 on cisco3560 and configured 2 ports to channel-group. Now trying to configure 2 other ports in Cisco2960, I dont...
Gday Everyone,I can not seem to create custom shape maps for WCS. Our school has a building the shape of somewhat-rhombus and anothe thats somewhat-pentagonal. How can I create th maps without intersecting with other buildings.Thanks
Gday All,Recently after upgraded our WLC and WCS softwares to 7.0. I have noticed an high ping rate to various servers, around 20 - 23 ms. Has anyone come around such issues?Regards,
Hi Leolaohoo,actually, I am trying to establish an etherchannel between 2 gig ports on 3560 and 2960 each. so far have created a port-channel interface, channel-group3 and assinged the channel group to the gig ports on 3560 and 2960. however, I ca...
Hi Leolaohoo,Could not run step3.however proceeded further and the diags are TDR test last run on: June 26 23:29:25Interface Speed Local pair Pair length Remote pair Pair status--------- ----- ---------- ------------------ ----------- --------...
