Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone seen an issue where the N7K CMP port only works at a gig? I'm trying to connect a CMP port to a 3550 being used as a out of band mangement switch. I can't find a way to change the port speed on the CMP. It only seems to work if I use a ...
I had the same problem on two ASA 5550's. Would just boot loop trying to load code after "booting system please wait". Replaced the memory and it booted fine.
The backups are from the remote site to the Data Center, so for the MPLS sites I could shape the backup traffic leaving from the remote site serial interface, I would use a time of day filter to limit backups only during the day. I was trying to figu...
In our situation the Hub router for DMVPN is also the Hub router for MPLS. Our issue is that we have backups at the DMVPN and MPLS sites we don't want them maxing out the bandwidth at the remote site. The best way of course would be to shape at the...
Should have read more. I found this http://www.cisco.com/en/US/docs/ios-xml/ios/sec_conn_dmvpn/configuration/15-2mt/sec-conn-dmvpn-per-tunnel-qos.html#GUID-182BD32F-56D4-479C-BFEF-B9738291E046Can't do QOS on the tunnel interface and physical interf...
I'm getting a simular issue. I have per tunnel QOS on DMVPN tunnels. Also have a serial interface with a shaping policy and it works but If I apply a shaping policy to the ethernet interface going to the my data center I get the following: R1(con...
