Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Everyone,Good daySeeking advice on this scenario in a client environment. We are trying to establish gateway reachability from PC2 connected in Cisco 9300 but not able yield positive result. Trunks are configured on Port-channel where physical i...
Dear Everyone,Want to ask if I can do hot swap or remove a 10G network module on an operating Cisco Cat 9300.If possible, need to relocate the unused network module that is in a production environment to another deployment.Thank you and best regards,
Dear Webex Experts and users,Just want to seek your expertise with regards to which app to use for a live streaming event. Webex app or Webex Meet app?thank you and best regards
Dear Webex Experts and Users, A non-profit organization had an event and it was livestreamed via Webex. Had an opportunity to be part of the tech team.The event had few numbers of live performance, music/videos for playback and hosted with emcee onsi...
Dear Everyone,Would like to know if its possible to establish a tunnel interface between R1 and R2 through below diagram. Tunnel interface not using the CE router.And if there is a relevant material that I can look so I can test it on a lab.Thank you...
Hello dear,I like your perspective on this. I think L3 switches models varies on their functionality, its either built more on switching or routing.Fellow community experts have mentioned their great thoughts on this. Best of luck brotherbest regards...
dear Hamza-ali, As mentioned by fellow community members above,Please check if trunk is established between the distribution switch and the 3560 switch. please compare output from the following commands on both switches (if possible to also share her...
Dear, Both switch running with rstp. Connectivity is established after modifying the trunk configuration on each interfaces of the switch.Best Regards,
Dear Everyone,Thank you for your insights and help. I got back to the remote data center few days back and was able to establish trunk.On Cisco 9300, port is configured as regular trunk port, port-channel is removedOn Dell S5248-ON, port is configure...
