Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,There is an inherited limitation on the number of span ports on the Cisco switches. this limit is 2 local span port and 64 rspan.There is a work around to expand that using Virtual Span to increase the numbre of desination port.In my setu...
Can PIX 506E be used in a basic hosting environment ? If I have few web servers on the Internet with no Inside interface ( Only DMZ ) and all I am looking for is One-To-One NAT, SYNC flood protection and DoS protection. Can 506E do that ?What is the ...
Is the following configuration supported ?PIX Version 6.3(1)nameif ethernet0 outside security0nameif ethernet1 support security95nameif ethernet3 inside security100.access-list support-in permit tcp any host My_Host eq wwwaccess-list support-in permi...
Hi,Is there a way to control the assert-time out / prune time-out in PIM dense ?I want to reduce the 3 min wait an interface in DM stays in prune before trying to re-forward again. Practically speaking, the 3 min time-out is leading to an unacceptabl...
Hi,Thanks for your reply,I was able to find an alternative way to do so. By using VCAL and the capture command. The only caveat is this has to happen on per vlan basis not per interface. the destination could be a physical interface or a vlanthanks
Thanks for your reply,I read the webpage, but it does not specify whether the number (25,000) is for bi-directional traffic or not. And it does not have any similar scenarios of what I want to do. I have some experience with the higher models 525/535...
Thanks for the reply,for various reasons. I did not want to relay on the routing protocol in this setup. For one, I am using ip multicast helper-map command and I want to be able to recover in the scenario where the broadcast stream dies but not the ...
