Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am trying to configure an IPv6 only LAN (a small test setup which comprises of few devices) Wish list - 1. Router should take IPv4 from DHCP (currently working)2. Router should work as DHCPv6 Server (Currently working)3. IPv6 only devices shou...
Hi, I was using /64 earlier and it was not working then I went through some Cisco docs whic suggested that for NAT-PT & 64 it has to be (128-32=96) /96I changed it /96 and still the status is same. Regards,
Only encapsulation supported in Cisco IOS XE is 802.1q. ISL is an old story which nobody does in Cisco now. So, dot1q is the only option, it doesn't allows customisation.HTH.
RV042 has features like Smart Link Backup and Load Balance and they are pretty easy to configure. Let me know if you need to get this done. Just raise a Cisco technical support request here and would get it done for you. HTH
Hi,You can very well ports from 4ESG as WAN ports but there is a small trick to use it with SVI. If you are still struggling with your configuration let know, would ask someone from my team to set it up for you through a Webex session. Just post a Ci...
Best way to avoid any counterfeit product is to request support contract along with it or just ask for the product serial number in advance to buy a support contract for the same, Any Cisco partner should be able to tell you the status of product by ...
