Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a request concerning the recommended configuration of multiple UCSM's into two MDS 9148s. My current production UCSM (two chassis') is connected, via port channel groups, to the MDS 9148s; which are connected to one EMC VNX SAN. What I'd lik...
I have a B230-M2 that is going to be SAN booted to a VNX with an MDS 9148 in between. The vHBA's are seen all the way through to the Array, but when I go to boot via the CD/DVD Virtual Media nothing comings up. The server goes straight to: Reboot a...
I'm trying to allow pop and pop3s traffic through my pix to a 2003 Exchange server. Internally when I telnet to port 110 it works but when I try from the outside it doesn't work. static (inside,outside) [Public IP] [Internal IP] netmask 255.255.255....
I have a Cisco 1700 router hanging off an ethernet port on my PIX. The router needs to be able to create a VPN through the PIX and yes it has to go through the 1700. If I have the device connected directly to port ethernet 5 what commands do I need...
- UCS domains share VNX ? Yes- UCS are configured in Fibrechannel end host mode (NPV) ? Yes- do you need shared access to the same lun's from both UCS ? Yes- do you want a complete storage (lun) isolation between UCS ? No (The hosts are all ESXi serv...
