Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community,
i have clarification concerning stacking of Cisco Catalyst2960x.
i have a stack of Cisco Catalyst 2960x 48 port non PoE lan base.
I wanted to know if i can add or replace another Cisco Catalyst 2960x 24 port non PoE or a Cisco Cata...
Hello,
i have a pair of Cisco Catalyst 2960x as top of rack switch connected to Core Switch 3850x via an etherchannel lacp.
During a power redundancy exercise with the master cisco catalyst 2960x was powered down.
During this moment, the etherchannel...
Hello, i have a scenario with a router with an internet line with two public ip addresses routed on it.I want to create two different vpns on the two loopbacks with the same remote peer for different types of traffic. The problem is that only one cry...
Hi, I have an ASA 9.8 in multiple context. I recently noticed that when I write the conf, at the beginning of the conf, there is the comment of Written by and the time missing. The auditor is requiring this detail in the conf. Can you please assist ...
Hello,We have implemented Jabber on CUCM 12.5 and the PCs are connecting to Jabber service. Some PCs can connect successfully to all services while some PCs can connect only to CUPS while the login succeeds, Phone services, CTI dones. Telnet and ping...
Hello,
Thanks for your reply.
Here is the show switch below:
sh ver file is attached.
You are right the output of the etherchannel age is contradictory with the logs and the admin shut from the logs was done during the switching process of master a...
Hello,
The
interface goes down.
Switch2 was master on the stack of 2. Switch 2 was powered down
Etherchannel is made up of ports g1/0/52 and g2/0/52. Both were up before.
I masked some information but the concern is marked in Red. So it is not...
Hello Daniel, I am read the flexvpn on Cisco Live and the explanation was not straight forward. Your config is simple to follow and is suitable. I will definitely test it. thanks,
Hello George,i agree the VTI would be the prefered solution with a full cisco solution. Unfortunately, these are third party companies wher we do not have control on config and equipment.Some third party endpoint support VTI but not all. But agreed, ...
Hello,I am found the solution. The timestamps of the saved configuration is found on the startup config only not on the running.I was looking for the running configuration.
