Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody, on our network we are using a pair of Cisco Nexus 9K (9300) in vPC mode; the switches are configured with some SVIs, VRRP enabled, and make some static routing. These switches have been running for more than six year without a rebo...
Hello,
my question is pretty simple: is it possible to configure two (or more) vPC peer links between the two switches belonging to a vPC domain? The purpose is to configure a vPC domain where two different peer links are used to carry different VLAN...
I'm trying to figure out if it is possible to configure an ASA cluster (with spanned etherchannel) when the firewalls connect to third party switches configured as a single virtual switch (similar to VSS but not VSS). Since the spanned portchannel "s...
Hello everybody, this is my first post into the Cisco support forum. I've recently installed a Cisco UC540 with 5 SPA 504G phones to a customer site, but I was unable to configure some (supposed) simple things. The most important is to set up an ...
Hi, this is the output of the "show processes memory". Firmware version is 7.0(3)I4(2). PID MemAlloc MemLimit MemUsed StackBase/Ptr Process
----- -------- ---------- ---------- ----------------- ----------------
1 176128 ...
@Brian Whiting wrote:Can I set the MTU size dynamically on the port-channel on the 4500X side and the Nexus side without taking the channel down?Have you tried to change the MTU in the end? I'm more or less in the same situation, with a pair of N5Ks ...
Does the Portchannel or VPC requirement states that all the Ports participate in the Bundle should be of same speed (Example Gig 0/0 and Gig 0/1 of a switch) ?
Answer:- Yes you are right you need to have the same speed.(in your case both are Gig int...
