Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a way to set the radius framed IP attribute to the value from Active Directory msRadiusFramedIP while using IPEP? I can't seem to add any attributes to the Inline Posture Node Profiles. I can set the radius framed IP under the regular Auth...
I have an ISE Inline Node that I successfully added to my admin ISE node. After I added the inline node, I wasn't able to configure it until later. When I went back to edit the configuration, the admin node says it is not able to communicate with t...
I have a 3560X that is directly connected to an ASA 5505. I am seeing output drops on the 3560X interface that connects to the ASA. Below are the troubleshooting commands I have ran, but I don't see any indication to what is causing the problem.356...
I have a 2960S connected to an RSP 2300. The 2960S is currently running off of the RPS, and I would like to switch it back to the internal power supply. Can I just run "power supply 1 on"? Will this cause the switch to reboot? Also I am concerned...
Is there a way to force clients that are already installed to download an updated client profile XML file from the ASA. I have tried editing the existing client profile xml file on the ASA, but the already deployed clients do not seem to download th...
Do you have the Cisco bug ID for this issue? I am seeing this behavior also on version 8.2, and would like to see if there is a fix in the 8.2 train. We don't have the memory to go to 8.4.3.
Yes, I am trying to assign an IP address to the vpn client. In my authorization policy I have three policy rules, one for compliant, one for unknown, and one for non compliant. Can I use a non Inline Posture Node Profile for the compliant authoriza...
On the page where you customize the SMS message there is a field for the Destination. This is where you specify the SMS gateway e-mail address. My ISE has this set to sms@example.com by default. You would change this to whatever the e-mail address...
It looks like the EKU only lists TLS Web Server Authentication Certificate. So that is probably my issue. Did you have to de-register the inline node in order to install a new certificate, or is there a way to handle it through the CLI?
This is configured under the web page templates for the Sponsor portal. http://www.cisco.com/en/US/docs/security/ise/1.1.1/user_guide/ise_guest_pol.html#wp1068521It uses the configure SMTP server to send an e-mail message to the SMS gateway.
