Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just curious if anyone else has seen this behaviour? Cisco 2951 w/ HWIC-4ESW IOS 15.0(1)M5#sh ip flow intVlan533 ip flow ingress ip flow egress#The SVI sends the flow data just fine, however I also continue to receive flow data from most other inte...
lol, 11 years response later...there is a registration timeout value on the spoke interface you can change which will update the hub with a new periodic mapping. The expire time (hold timer) on the hub should also be updated.more information you cou...
better late than never I was looking for the same answer and came across this page. Dug into it a bit more and found this really good article someone else wrote with the answer:http://www.force10networks.com/CSPortal20/TechTips/0040_HighCPU.aspx
did some debugs / tests and found the following:- it is due to the SSH client configured to attempt key authentication first which the router is not set up for, therefore fails and falls back to keyboard interactive authentication.- tested with Putty...
same issue here.. I haven't started to troubleshoot it yet but I am receiving failed login messages after successfully logging in.running 15.1(m4), 15.1(m5) and 15.1(m6).I can confirm the only command I have enabled in common with SludnevTN is "login...
