Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The Cisco Prime documentation recommends configuring switches to send SNMP traps. However it does not give any more details.I was wondering what sorts of SNMP traps people in the community are using with Cisco Prime 2.1. I'm looking for some sort of...
Hey Guys,Trying to upgrade a switch using Prime. The switch Sync's fine with Prime, SNMP and Telnet/SSH credentials seem to work. However when trying to push an Image I get the following errors in the job description:Distributing image c3560-ipbasek...
Hey All,I have two WLANs configured on my WLC. One of the SSIDs is for some HREAPs at another site. I don't want the local APs offering the SSID for my HREAPs, nor do I want the remote HREAPs to advertise my local SSID/WLAN at the remote site. How do...
It seems like none of the 3850 Multigig Switches are supported either as of CNA V6.3 (latest in Nov. of 2017).
This has been an issue with one of our clients for a while. They are not very technical and prefer not calling us for simple port changes a...
I had the same issue.Even though my Service port was disabled, it had previously been setup with an IP on the same subnet as Managment (not service port) interface. I changed the IP on the disabled service port to something arbitrary and unused in ou...
We have the same issue.What I did notice is that for our 3560s, 2921s and VG224s, this is not an issue. Those show up with their correct neighbors. However, all of our 2960s and 4500's do not show their neighbors in the PI topology view (of course if...
I just tried creating a CLI template with the following config and pushing it to one of our 2960X switches and it worked:in ra g1/0/5 - 10 description TestWorked end Here was the result:#sho inter statusPort Name Status Vl...
Interesting note:I found that when using the "Software Deployment" instead of the "Image" tab under a device in the "Device Work Center" to do upgrades, I encounter this problem less often.However the problem still does occur at times and an addition...
