Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I've recently ran into a bit of problem with an added network segment.The basic network before said addition has clients connecting via distribution 2960s up to a 3750 which has L3 vlans IP routing enabled this sends all traffic to a CPE MPLS d...
Hi guys, I recently made changes to my network and I can get out to the internet but when I try google.com I can't browse to it, and I noticed that I also can not ping the sites I do browse to, I'm figuring its a return traffic problem wondering if a...
Hi guys, I've run into an issue creating a new internal network for secondary MPLS connection.I'm attaching a diagram of what the network looks like. In the diagram clients 1-2-3 all connect internally with no problems from one to another and they p...
Hello all, I've looked around lots for deploying MPLS using VRF where a single router is used at the CE location and how to go about accomplishing this.I'm trying to achieve something slightly different and I'm trying to figure out if a route map or ...
Hello I am running into an odd issue with clients connecting from one of our remote sites to our offsite email servers via owa - web connection.I'm attaching a visio to show a better understanding of what is happening but I'll describe it here as wel...
Ok cool, the phone is PID VID: CP7962G V15The phone was running on CUCM 9.1.2, but i am now using 8.6.2I don't know if it makes a difference, downgrading the firmware looking at this I'd say this is your problem. Its likely you upgraded the firmware...
You can probably accomplish this doing EEM scripting, but from a purely solution based view, I think assigning a VIP to 2 servers and configuring them for fail over may give you better results. In this scenario you have 2 servers sharing 1 virtual I...
Asus you have 2 ways to do this:1- i will separate the vlans among the switches (for example vlan 1&2 o switch 1, vlan 2 &3 on switch 2etc..)2-i will create subinterfaces on the router with encapsulation dot1q vlan number and dhcp helper under each ...
You make a very good point Jon Im assuming the sonic wall is NATin but it may not be - which would explain why I had to put in the route for 172.19.2.x on the ASA. I did this without thinking it through it simply clicked in my head that return traff...
Well yes the clients on 172.19.2.x have a gateway of 172.19.2.5 (sonicwall)This sonicwall has inside interface 172.19.2.5 this sonicwall sends all 0/0 (web) traffic to 10.10.10.3 (sonicwall interface directly attached to switch) Switch has GW of CE ...
