Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is DSCP marking backward compatible with IP Precedence values ? I have an teams application which is tagging the Voice traffic EF and Video traffic AF41. However, our ISP uses IP precedence for QoS Queuing. I am just wondering if I would be ok to sen...
I have been investigating how to restrict administrative access to FTD firewalls. Our corporate policy requires that we:
1) Enable SSH with Radius Authentication
2) Restrict IP address which can connect to the firewall.
When you install FTD on a ASA ...
Has anyone has any experience migrating from ASA using firepower services to FTD ? I was not able to find if ACP which are used for the Firepower Module can be applied applied to the FTD firewall once the firewall has been upgraded ?
We are current...
What is the difference between the commands "Sh controller t3" and "sh controller serial x/x" ?They are for the same controller but give different outputs.XXXXXXXXX>sh controllers t3T3 1/0 is up. Applique type is Subrate T3 No alarms detected. MDL...
Hi,I just needed more insite into the function of the ip tcp adjust-mss command which can be used to adjust the MSS value in the tcp syn packet which passes that interface. But here is a question which I had. Consider that i have two sets of systems ...
The bug tells that the issues are seen with DC1400 Power supplies. But in this case, it is a AC 2800W. Is this bug applicable to AC power supplies as well ?
