Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have an ASA on the edge of my network. When I traceroute from an outside host to an inside host, the last few hops all appear as the NAT IP for the inside host.
I have turned on ICMP inspection and ICMP error inspection.
I was able to replicate...
Hi,
We're soon going to be deploying a pair of ASA5525-x's in our data centre. I had planned for them to be clustered, and run multiple contexts. These contexts would be a combination of routed and transparent modes. I also had intended to run FireP...
Hi,
I'm looking at an ASA, which has a default reference bandwidth of 100Mbps. This will form a neighbour relationship with Nexus switches which have a default reference of 40Gbps.
The links in the DC vary between 1Gbps, 10Gbps and 40Gbps. I would l...
Hi,
I'm looking at implementing the Nexus 9k soon (I have used 5k's previously). I see that static MPLS is supported (although no LDP).
What is MPLS used for on the 9k platform? I am assuming that they're not a service provider switch, such as the c...
Hi,
I may have to design/build a very small (single rack) data centre presence in a location that is remote to our existing data centres.
I'm considering deploying vxlan in the primary (existing) DC and in the potential new one. This is for L2 adjac...
I have had a look at this document:
http://www.cisco.com/c/en/us/td/docs/security/asa/asa90/configuration/guide/asa_90_cli_config/inspect_basic.html#pgfId-1541261
From here I can see that normally (without icmp error inspection), the ASA will transl...
Thank you.
I spoke to a Cisco account manager about this, and they said that the road map for these features is v6.3
This is tentatively scheduled for around March/April 2017.
I did see that, but I think that is to compare OSPF's cost-based metric to RIP's hop based metric.
Running 'show ospf | inc bandwidth' shows that the 'Reference bandwidth unit is 100 mbps' which suggests that it is still used.
