Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am running a 1921 router and use it partially as an AnyConnect (WebVPN) server for remote access into the location. The certificate I used was a self-signed certificate & trustpoint generated on the router. I am running the latest IOS track avail...
The various documentation out there for the 1702i AP's have some conflicting specs. Can anyone who actually has one please verify the PoE requirements? Will it run at full capability under the 802.3af 15.4 watt power envelope? Or does it require 8...
The feature list for IOS 12.x and 15.x for the Catalyst 4500 series specifically says it does not support reflexive ACL's or CBAC (unlike the bigger 6500 series). However, release notes for IOS XE 3.5.0E or better make no mention of it at all.Can an...
I got this working on a Nexus 7700 running 7.3x and I didn't need to put in the both route-target import and export commands in the same vrf. It works fine. Did something change in recent code?
vrf context host1 address-family ipv4 unicast route-...
I'm seeing this message repeated thousands of times on my Nexus switches as well. I tried turning off the Remote Access Multilink in NPS (as suggested in another thread), but it had no effect.
Is there another way to stop NPS from sending this?
Wha...
