Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have encountered a situation with an installation where a client is using WCCP on a C3640 router to redirect and load balance web requestes to a Squid server farm. The client replaced their PIX 515 firewall with a Juniper SSG550(running ScreenOS 5...
I would like to exchange IGB routing updates between my routers on a providers MPLS network. My connection to the MPLS cloud is typically a point-to-point. I configure and install these networks for various clients and, therefore, work with multipl...
I have a configuration where I am doing BGP peering two different service providers and using HSRP to control outbound failover. One of the service providers (SAVVIS) recently installed two additional T1 interfaces into my router that connects me to...
I am trying to get a IPSEC vpn tunnel established between a PIX and a Microsoft ISA server. Does anybody have any good references for how to configure the PIX to get this working?The VPN tunnel worked prior to the client replacing the PIX at the hea...
I have encountered an issue with a CheckPoint SecureRemote VPN client running through a PIX-515e firewall. The client appears to connect, and traffic seems to be getting to the CheckPoint firewall, but the client does not receive any responses. The...
It appears as though the rtr command is only available with certain IOS feature sets.But I was able to use the track 10 ip route A.B.C.D/30 command, which I believe will accomplish the same thing. I then added "standby 2 track 10 decrement 10" to my...
Thank you. I think that may solve my issue. I assume the following rtr commands must also be applied:rtr 1 type echo protocol ipIcmpEcho timeout 1000 frequency 3 threshold 2 request-data-size 1400rtr sched 1 start-time now life forev...
Thank you for the responses. I have enabled NAT-T, but I have not opened UDP port 4500: I will give this a try. The VPN client and PIX firewall are remote to me (in Florida), but the person at the Florida location said he has reinstalled the Secure...
The uplinks on switch 2 and 3 only appear take the speed command, not the duplex command. I thought the same thing about hardcoding these settings, but the Cisco documentation indicates that the 1000BasT ports only use full duplex.I discovered that ...
