Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
CUCM 9.1, VCS Control X8,6From jabber I want to dial to EPs registered to VCS Control using <alphanumeric alias>@vcs.domain. - On CUCM I have created a sip trunk that points to VCS Control (I also created proper xforms on the VCS Control).- On CUCM I...
I have a VCS Control X7.2.1 and CUCM 8.0. The setup is otherwise working correctly except for one issue. When a VCS registered video device is connected with a phone on the CUCM side (internal or on the PSTN), if the phone on the CUCM side hangs up t...
I am doing some test calls using a phone registered to CUCM (version 7.x) calling to an MCU5300 (latest 4.3) through a VCS Control (X7.2). I only want to do voice calls using the CUCM. Also, I do have a SIP trunk (neighbor zone using the CUCM profile...
I have a TMS appliance. My question: is upgrading TMS directly from 12.6 to 13.2.1 prohibited? I have not done this specific version jump......but I did not find documentation that prohibits it (my apologies if I missed it). However, a fellow field p...
In the TMSPE deployment guide it states "Cisco TMS Provisioning Extension Option Key: Must be added in Cisco TMS".I have performed a fresh 13.2 install and the Movi 25 license key is already added successfully. At this point do I need an additional T...
Hi Debudas, Did you get this resolved? I am having the exact same issue (after recording starts a subdirectory is created on NFS share, no errors in the logs, but no video file ends up in that subdirectory).
The issue remains unresolved. A couple of items: (1) There was not an .xml file on the TFTP. So jabber was using the default (which has URI dialing disabled. (2) I used the jabber 'configurator' to create the configuration with URI dialing enabled (...
Hi Martin,No I did not find a solution. SIP to SIP calls initiated on the CUCM side will not disconnect. The ultimate work around is I configured the VCSC search rules to force all VCSC<->CUCM calls to be interworked to H323 on the VCSC side. With t...
