Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Comparing an older SPA122 (v1.3.1 (003) ) and a ATA192 (v11-1-0MPP0401-002) the "Help" section in the top right corner of the GUI is missing. While I understand that I can use the admin guide and provisioning guide, why would they remove a help secti...
I am functionally testing a Cisco ATA192 on firmware (11-1-0MPP0401-002 Oct 18 2020) and the 1st call waiting tone sounds like a staic-fax tone mixed with the phones regular ringtone and then the second CW tone sounds normal. I noticed that the CW1 c...
I am testing an ATA-192MPP on firmware 11-1-0MPP0401-002 . I've found the SSH function which I have been hoping for at least 5-7 years. I am able to login via SSH but once I get in I receive a second set of login/password prompts that I can actually ...
I have a UC540 and UC560 PBX. Assuming neither of them has any VWIC cards installed, are either compatible with the 2 VWIC's below on the IOS' below?
VWIC3-1MFT-T1/E1 (1-Port 3rd Gen Multiflex Trunk Voice/WAN Int. Card - T1/E1)
VWIC3-2MFT-T1/E1 (2-P...
I've noticed when the SPA122 dials a call and receives a SIP 484 "Address Incomplete" response from the call agent, the call agent plays an announcement "call cannot be completed as dialed" and then the SPA plays what sounds like a dial-tone. It's ac...
Hi Aseem,
I have a UC540 and UC560. The UC540 came with a pre-installed VWIC2-1MFT-T1/E1 that I moved to the UC560 which has its' own integrated T1 port. The UC560 works fine with 2 PRI's.
I am trying to replace the VWIC that I removed from the UC540...
Hi HameedI just received complaints of this exact issue with a SPA122....did you ever find out if there's to cut off the voltage when the lines are unregistered or no link on WAN?Thanks,George
Sam, yes it is available. I am testing on 1.3.1-003 and 1.3.2-007 though so it may be recent change after 1.2.1-004.Here's what it shows after I post that URL:SPA122 will upgrade to the new firmware when it is not in use. Fast blinking of the Status ...
I haven't experimented in a while but I think that it doesn't check for FW unless it's initial provisioning, you've updated the upgrade rule or POST (just login then past this into the address bar) to "http://YOURIPHERE/admin/upgrade" to tell it to ...
I used one of the SPA rebooter app's that are floating around the forums (http://www.freymond.ca/SPA112/) to reboot the devices (batch file to re-run the procedure on each device) and then used CURL to push a provisioning XML file called "upgrade.xml...
