Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a question concerning the syslog detector for an EEM script using TCL. Sorry if this is already covered somewhere else I could not find relevent info with a search. I have a TCL script which kicks off if a T1 flaps because of LOS (syslog...
Hello,I have a question concerning the area id in an ISIS NET ID. According to documentation I know that a level-1 router can only become neighbors with a router with the same area but level-2 routers do not care about area ids. Using area ids a netw...
Hello,I am wondering if anyone is familar with a method for testing an EoMPLS L2VPN circuit built to a new router with no customer interfaces up yet. For example if I have a PE ASR901 router and I build a L2VPN circuit to an interface that is not up/...
I have a question regarding enforcing a QoS on Pseudowire packets coming from a T1/CEM interface on an MWR2941. I have the TDM pseudowire working great testing in a lab with two T1 testsets. The problem is prioritizing the T1 traffic so that on small...
Hey Xander,Running into a problem with BNG over PWHE. I'm seeing packets sent from the far end PE but drops on the BNG. Any ideas or should we engage TAC? !!! Far endPW: neighbor 10.46.1.115, PW ID 3033, state is up ( established )Statistics:packets...
Thanks for the quick reply. That makes sense for the p2mp data trees for video sources.Are there any considerations if we don't support SSM and require *,g joins from receivers? We also use BSR for group to RP mapping.In a network with PE routers con...
Hey Bruno Great article. Question, for a typical IPTV Mcast design with several source PE and many receiver PE routers will profile 14 work with just p2mp? Since each PE source PE has unique groups this wouldn't be considered mp2mp would it (eg profi...
Hey @Bryan Garland Can you confirm if it is expected then for FPD upgrades to timeout on an upgrade from 5.3.4 to 6.4.x or 6.5.x? We recently had an upgrade with auto fpd enabled that timed out after 90 minutes and required manual upgrade and LC rel...
Hey Xander,
Great article as always. Question on BGP route injection. I have a scenario where our upstream peer only accepts /128 IPv6 host routes. I need to match conditionally on a /64 network inside an L3vpn and then inject the /128 to my eBGP p...
