When attempting to join two calls I get a message indicating Cannot Complete Conference. Attempts have been made to put this on the Hold softkeys and Active Call softkeys, both to no avail. Any thoughts?
I'm looking at upgrading this box and have two questions:1. Are the cards hot pluggable?2. I currently have other cards in the box and wondered if there is a sequence they need to be installed? Currently there are (2) 32 port 1 GB cards and a 16 p...
Dan, Did TAC get back to you on a resolution? We're running 10.5.1.10000-7 here and experiencing the same issue. I tried November and December and both failed to go out the full month. Thanks.
That makes sense, Rick. There are (2) 16 channel DSP's in the box, a single PRI and (4) FXO ports. So at this point, there's no hardware conference bridge built in the box, and I don't believe one can be either given the resources on the box.
