About bava_ccna

bava_ccna · 04-26-2012

Hi Friends,I am having a question regarding the pros & cons of Network Support Vs Network Testing field in IT Industry.Having 6+ yrs of experince in Netwroking field and currently working with testing profile.Holding CCNP & CCIP (MPLS&BGP) Certificat...

bava_ccna · 04-26-2012

Hi Friends,I am having a question regarding the pros & cons of Network Support Vs Network Testing field in IT Industry.Having 6+ yrs of experince in Netwroking field and currently working with testing profile.Holding CCNP & CCIP (MPLS&BGP) Certificat...

bava_ccna · 05-30-2011

Hi ,I have a doubt about ospf behaviour in Broadcast multiaccess network. Why do we require DR & BDR in ospf broadcase multiaccess network???I read a CCIE book says that DR/BDR are used to avoid flooding of LSA. Is that true? OSPF is using muticast f...

bava_ccna · 04-11-2011

I have read the MPLS Fundamentals book by Luc De Ghein, So I understand from the from book that cef needs to enabled in edge routers to tag or untag labels (for Ip packets). I am eager to know why Mpls (Not a cisco proprietary) depends on a cisco pro...

bava_ccna · 04-05-2011

Hello All,I have a scenario like this, using bgp in a multihomed network with two different ISP. my intension is to acheive loadbalancing in both inbound&outbound direction. I have subnetted my prefix 82.x.x.0/24(for example) into two 82.x.x.x/25 pre...

bava_ccna · 06-28-2012

Yes, you need IGP routing between the ebgp peers if it's not directly conneted. By default,ebgp session can be established only if the destination is 1 hop away, this is because TTL is set to 1 in ebgp OPEN msg..So if want to establish ebgp session b...

bava_ccna · 06-28-2012

Yes, its relatively easy to do so but make sure to apply a filter to accept only default routes from both ISP if you don't want complete routes due to memory concern..Pls rate the useful posts-bava

bava_ccna · 06-21-2012

Hi,You have to apply the policy in the ingress interface of R1 (i.e fa1/0) and also you don't need two different route-map for acheiving this. Match the access-list in two different sequence of the same route-map and assign a different next-hop for e...

bava_ccna · 06-14-2012

Interesting,I am also looking for this solution..-bava

bava_ccna · 06-13-2012

Hi Karthik, If you configure OSPF LFA then it will show the backup path as well..Not sure whether OSPF LFA is avilable with IOS however its there in higher end routers with IOS XR..HTH-bava

Member Since	‎12-18-2006 02:37 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	80
Total Helpful Votes Received	3

User Statistics

User Activity

Networking Career

Networking Career

OSPF DR & BDR question??

Why CEF needed in MPLS Network??

BGP Loadbalancing with multihome network

BGP Multihop Routing?

Multihoming using single router

Re: connect to 2 ISP using route-map

EIGRP Variance & Traffic distribution count

OSPF Backup paths