Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm running CCM 4.1(3) and Unity 4.0(5). If one particular subscriber is busy, I want callers to have the option to hold or leave a message.The problem I am facing is when this subscriber is busy, the caller hears about 2 seconds of MOH, then goes t...
I just did a lab where the scenario was vlan information was not being propagated over a trunk link (only 2 switches in this lab). After checking the obvious (eg trunk is operational, matching vtp domain names, etc.), it turned out that you had to i...
Suppose we have one router connected to an L2 switch, and pc A (in vlan5) and pc B (in vlan 10) are connected to the switch. The router has a default route to the ISP (ie for internet connectivity).We want pc A and B to access the internet, but they...
suppose we have 2 computers, pc A and pc B, connected to one switch (both on the same vlan). the ip on pc A is 192.168.0.1/16, and the ip on pc B is 192.168.5.1/24. will they be able to ping each other? [i said no because pc's act like rudimentary...
Pardon the delayed response, but I am currently out of the office and won't be back till Monday.In the scenario callers dial the user directly (I should have mentioned that in Callmanger, I have checked "call forward busy" for the subscriber's device...
Great.Thanks again everyone for your timely responses (especially Edison).This is exactly the sort of thing that encourages quality participatiion in the Cisco forums.
