Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a new setup, here we have 3 routers and two ISP.I am running OSPF and IBGP in my company. Let named then as A, B and C.A is connected to ISP X and C is connected to ISP Z.OSPF is running on A, B and C. IBGP is running on A and C with loop Loop...
Hi michelerossi,(Please Rate)See the below link for detail on IPv6 Redundancy Protocols.http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-fhrp.html#wp1071450
Hichialun,(Please rate)MAy be you are using c1900 switch. You can the delete the vlan in the fellowing manner.Switch_A#vlan databaseSwitch_A(vlan)#no vlan 250Switch_A(vlan)#ApplySwitch_A(vlan)#exitYou also use the below stepsPlease note this requirs ...
Hi rebrokenglass,(please Rate)Reply to Q1 3500 is a L3 switch and by default all port are in trucking dynamic desirable mode. Thus the uplink can be a trunk port or an access port depending on the configuration on the port to which the switch is atta...
