About Ramoonus

Ramoonus · 03-27-2008

HelloI have 2 cisco 2501 routers, (1E and 2S ports)I have attached each ethernet to a different part of the LANI have put a db60-db60 cable on the S1 ports of both routers10.0.x.x network SwitchA--ethernet--RouterB <-Serial-> RouterA - SwitchB 10.2.x...

Ramoonus · 04-01-2008

ive found itone of the cables was placed upside down 

Ramoonus · 04-01-2008

------------------ show running-config ------------------Building configuration...Current configuration : 725 bytes!version 12.1service configno service single-slot-reload-enableservice timestamps debug uptimeservice timestamps log uptimeno service p...

Ramoonus · 03-28-2008

I have a DB-60 serial cable between 2x Cisco 2501Ethernet routerA is 10.0.0.0/16 networkEthernet RouterB is 10.2.0.0/16 networkI want to establish a connection between these 2, but i get the message that the link is DOWN, while the config says the l...

Ramoonus · 03-28-2008

Thank you very much evsrajatgupta !I think this will just do the trick but i cant test it untill tomorrow.

Ramoonus · 03-27-2008

the easiest way in my opinion isrun CNA 5.x on the pc, connect to the switchlet it do all the settings and transfer over ethernet/http

Member Since	‎02-22-2008 06:54 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

Cisco 2501 lab problem

Re: Cisco 2501 lab problem

Re: Cisco 2501 lab problem

Re: Cisco 2501 lab problem

Re: Cisco 2501 lab problem

Re: HOW to upload IOS on 3560 Switch