Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all ,
I want to integrate CUCM system with Active Directory so all users will be managed by AD and I know that could be done by LDAP configuration on cucm , but what I need to know is that if we can add all data on active directory (Username ,...
Hello all ,
I have configured an E1 Controller on voice gateway but I have to edit the PRI group from 1-31 to 1-10 but after any restart to the router it reset again to 1-31 and the outgoing calls stopped so any solution for this issue I tried to sa...
Hello all ,
May be the title has a lot of confusion but I will explain briefly :
We have BE6K server configured and a Voice gateway with 2 FXO one of them configured and connect to Teleco. the second will be connected to the Fax machine through ...
Hello all ,
I have the service contract for a cisco licenses and smartnet but I don't know where to go to check and verify them.
any one can help me here ?
Regards
Hello all ,
I have configured an MGCP gateway on CUCM 10.5 (FXO Interfaces) and everything goes fine in inbound and outbound call except two things.
1-When I try to call from my mobile to the Attendant DN (Cisco IP Phone) which received the call it...
I make the configuration on the active directory by adding users including his IP Phone number , I don't know if it possible or not for cucm to get this ext number from AD , I follow the configuration in Mohamed video and it synced all the users succ...
Thanks Suresh I got the point from you as usual.
What I need to know to remove any confusion is : I can't use the same prefix on the 2 FXO while using the same H.323 ?
