Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,
I need some advise on the following, what do these files mean such as what is term42, jar42 etc as shown below, as far as I know these files is for 7942 phone.
1.term42.default2. jar42sccp.8-3-4-16.sbn3.cvm42sccp.8-3-4-16.sbn4.cnu42.8-3-4...
Hi Experts,
I need your help in trying to resolve the supervisor engine failure in the 7609 switch. The error is shown below please view and advise:
I need the 7609 to pick its ios image and boot properly, please help....!
-------------------------...
Hi Experts,
When I do a show run these are the only options shown..! The problem is that I am unable to configure the interface?
Interface configuration commands: default Set a command to its defaults description Interface specific descripti...
Hi Experts,
I need to get some insight on this issue as when I try to configure an interface with a IP address and save it..! IT DOES NOT SAVE?
What seems to be the problem. This problem started from the time a reset the device to factory default an...
Hi,
I have tested everything using the document in the link but still no progress:
http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6000-series-switches/17050-14.html
Will you be able to share more of your expertise.. since the issue here...
Hi,
I have tested everything using the document in the link but still no progress:
http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6000-series-switches/17050-14.html
Will you be able to share more of your expertise.. since the issue here...
