Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
can anyone advise on what cut off on AS-PATH length would be when accepting routes from peers, looking through some of the received routes the AS+PATH is pretty high and I would like to limit this down, is this strictly necessary ? If so what would ...
Hard to tell without seeing the config, you mention the cisco switch does not have the IP address that the industrial switches are using as there GWIf it is not there you will need to add it under and SVI and trunk the relevant vlans to the industria...
You can use allow as in or as overide, on the CE or PE respectively.If I understand your query about the loop within the site with the two CEs then this shouldnt be an issue as ibgp vs ebgp with regards to routing should overcome this;You want both C...
the version is point 1 is so old I would assume it is eol and eos by now, either way you should have moved onto something newer by now.version in point 2, see belowhttps://www.cisco.com/c/en/us/products/collateral/switches/catalyst-2960-x-series-swit...
