Level 1
Level 1
Member since ‎02-01-2012

User Statistics

  • 13 Posts
  • 0 Solutions
  • 10 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

Equipments:1. I have 5 workstations with 2 servers but the backup server (black) is shut down intentionally. 2. I have 1 cisco gigabit unmanaged 8 port switch and 1 cisco 1941 vpn router.Scenario:The cisco 1941 vpn router is configured for IPVPN conn...
I already googled through this but they are showing the catalyst switches.how to check if ip routing on Cisco SG300-28 layer 3 switch is enabled? it doesn't show on the running config.I am trying to setup inter-vlan routing on the sg300-28 switch.I s...
I have 2 cisco 1941/K9 vpn router. i have configured both with LAN ip address given by our vpn provider which is and the other is IP addresses are configured to GigabitEthernet port 0/0 on both routers.1. Is it possible t...
I have three Cisco SG300-28 switches. I setup a test lab environment with a core (server) switch in Layer 3 mode and the rest are (clients) in Layer 2 mode. As I understand, these switches doesn't support VTP, only GVRP. And GVRP works the same with ...
it says that the cisco sg300-28 managed switch default system mode is Layer 2. but i want to change it to layer 3.i have read the admin guides and googled it already but i can't get inside the "Console Interface Main Menu" where the switching from L2...
Community Statistics
Member Since ‎02-01-2012 09:48 PM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 13
Helpful Votes Given To