Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,customer is using lots of 2960-Switches and plans to implement ISE for dynamic VLAN-Assignment. Should be no problem.For lots of small offices he wants to purchase SG300 Switches. I recommended Cisco Compact Switches, but they are too expensive...
Hello,just implemented two AIR-SAP2602E-E-K9 as bridge-pair with directed antennas.When using the "show dot11 ass all" command, I can see the actual data-rate on the air. But this models show something like m7b2 etc.Can somebody give me an explanatio...
We need to connect two buildings with wlan. Due to the environment we will use AIR-ANT2410Y-R Yagi Antenna. What actual AP (IOS-based) supports this antenna. Is the AIR-SAP2602... the right choice? And how to configure the AP with only one antenna-ca...
Hello,in the "ASK THE EXPERTS - WIRELESS LAN CONTROLLERS " terminated in August 2010 a question was asked regarding the support of multiple vlans with WLCs.The answer was: Yes, you will be able to pass multiple VLANs using WGB in the 7.0 release, bu...
Hello,we have a scenario (see attached drawing) with 2 servers connected to two Cisco 6509. These servers ar configured for MS NLB. We have done the necessary configs on the 6509 (static arp, and static multicast) according to this document:http://ww...
Hello Phil,yes, I still have connectivity problems. On the MPLS-Routers I can see the arp entry, but not the mac-address entry.Traceroute from remote site stops at the MPLS-Router.Traceroute inside LAN (from different VLAN) is ok. LAN-Router is Catal...
Hello again,sorry for comming back with this problem. I thought it could be solved by adding the appropriate commands in the MPLS-Routers.The MPLS-Provider could set the "arp x.x.x.x H.H.H ARPA" command but not the mac-adress static command.I tested...
Hello Phil,you are right, the MPLS-Router is connected to the VLAN where the servers are.So I instructed the provider to implement the appropriate entries. But this still lasts. So hopefully this will solve the problem.Thanks again for your support.
