Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,I have a Cisco 881G with PCEX-HSPA-3G card for which I have successfully configured for internet. As the above one has come to end of life, we got the replacement 881G with embedded 3G modem.I can't get Cellular 0 to use ppp encapsulation: Ro...
Hi Guys,We have a 881G router which is connecte to internet through 3G (IPv4 DHCP).I have been given a requirement to translate the communication from the IPv6 clients to IPv4 internet.I have configured the DHCP part.. but I am stuck translating the ...
Hey Guys..Can you tell me if the router automatically connects to internet even if you dont do a ping test?I have configured a 881G with PCEX-HSPA-G module and the Cellular interface never comes up untill I ping any internet IP from the router CLI. I...
Hi, I am receiving traceback logs in the 881G with 3G module.And after reload, the router is going to Initail Config mode.Could you please let me know what the lates IOS is??Current IOS I am using is c880data-universalk9-mz.151-1.T3.bin.Also could yo...
Hi Guys,We got a new 881G Router for Lab testing.I could get to internet through the 3G sim. But the problem is that I am unable to connect to internet or ping public IPs from my LAN or VLAN.Please check the below config and let me know if I need to ...
Hi,Tried that but there is no data for the current IOS I am using.When try to put the IOS in the Cisco Navigator, it gives an error telling there is no version.Any helpThank youArjun
Hi,Nope, when I enter the "encapsulation ppp" under cellular interface, I get the error message shown in my 1st post.Can someone help in getting the updated IOS for c880data-universalk9-mz.151-4.M4.binArjun
Hi Sandeep,Thanks a lot for the reply.I currently have the C881G+7-K9 with embedded modem where we do not need any express card and just need to insert the SIM card in a slot available behing the router.So this IOS holds good for this as well?Arjun
Thanks for the reply.I want my IPv6 hosts connected at the LAN side to be able to access IPv4 Internet.So guess it is obvious that I need the router in the middle to act as a converter and if that is the case, need to know the way to perform the conf...
