Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Quick question. I know bgp bestpath as-path multipath-relax is working for IPv4, but what about IPv6 route loadbalancing? I did lab it in GNS3, but it didn't give the expected output for IPv6. For IPv4 before/after implementation of bgp best...
Hello
I could need some help in regards to AnyConnet running on a Multiple context ASA 5585-SSP10.
I think I have most of the configuration in place, but still I continously receive an error in regards to Apex licensing.
Group <anyconnect> User...
Hello
Any suggestions as to what I might do wrong? I have some switches with multiple L3 VLANs with IPv6 enabled (SLAAC). Everything is working, however, when I look at my IPv6 dhcp bindings, I get A LOT of clients (duplicates). It is essentially c...
Hi all
Would any one be so kind to look at my config and tell me what I am missing. I am to configure several site-to-site VPN. Since the local subnets can be overlapping, I want to use vrf-aware IPsec towards different customers. If I however try ...
Hello
We have a couple of customers running the Cisco ASA botnet-filter. However the auto updater hasn't been working for a couple of weeks.Do any of you know anything about the issue or have the same issue?
Symptoms:- When ever the dynamic-filter ...
Since you where the only one to reply, and that you probably would have spottet the error when I posted the configuration, I accept your answer (but as I stated I didn't state maximum-paths under address-family ipv6)
If you have configured AnyConnect to be working under a virtual context, and you e.g. upload a new AnyConnect version (including the webvpn configuration), then you don't need to configure anything for the auto update to work. It will upgrade any cli...
