Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking for some help getting my AnyConnect VPN (namely split-tunneling) working correctly behind my Ubiquity EdgeRouter. Currently, my (cable) Internet connection is coming into eth0/0 of my UBNT EdgeRouter, I have some vLANs configured on my ...
Hello everyone,
I'm having some trouble wrapping my head around how to accomplish something in my lab. Right now I have an ASA5510 configured with eth0/0 as my outside (dhcp), eth0/1 as my inside (10.10.10.0/24 with DHCP), and eth0/2 as my dmz (172....
Hello everyone,
I have what will hopefully be an easy question for the experts here on the forums.
What I am looking to do is have a Cisco AnyConnect VPN co-exist with a Citrix Netscaler Gateway on a single Public IP. In other words, I would li...
Hello everyone,I am having a little trouble with routing and looking for some help or guidance. My setup is my ISP (Cable) comes in to my Motorola SB modem --> goes to my Cisco 871 FastEthernet4 --> out of the FastEthernet1 (plans to eventually move...
Hello,I am having a bit of an issue with my Site-to-site VPN. I am connecting an 871W at a remote location back to our Corporate office ASA 5520. To this point, I have created a network device in the ASA for the remote network and a network group f...
Just a quick update on this; I was able to resolve this by adding a route within my Ubiquity EdgeRouter for the IP range of my VPN pool that is local to the ASA (In this case it is 172.20.50.0/28). So within the EdgeRouter, I did a static route fro...
Marvin,
Thank you for the response. I hadn't thought of putting the AnyConnect on a different port. That's a great idea along with the static NAT and access-list for the CAG.
I'll move the anyConnect to another port and then leave the Access Gate...
Hi Jon,I just wanted to provide an update on everything. I didn't have a chance to update the forum, so I wanted to provide an update. Everything is working perfectly now. I am able to route through the ASA without any trouble as well as reach my ...
Jon, Thanks again for your advice. I believe that is what I am going to plan on doing then eventually. I guess the next logical question is, do you recommend taking the 871 out altogether and make the ASA my edge "router?" I would prefer to keep th...
Jon,Thank you for the information on the ASA. I have actually saved that to my Evernote, which has become my Knowledge Base for everything -- I have been adding notes for everything I have been changing with my configs as well, so this has been a gr...
