Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am in the beginning phase where a customer wants to change their routing protocol from EIGRP to OSPF on their network. I noticed that they have a DMVPN setup with about 25 sites each with a single tunnel interface going back to their respective wan...
We are going to be deploying a smaller data center vxlan design with basically two spines along with four leaf switches which will be paired in a vpc design at the leaf layer. I have read the best practice for backup routing across the peer link is e...
I am trying to re-mage an SFR module on an ASA but when I do a system install via ftp, I get a permission denied error. I have ruled out the FTP server as the issue as I am able to FTP to a totally different set of firewalls so that should rule out t...
I am trying to re-mage an SFR module on an ASA but when I do a system install via ftp, I get a permission denied error. I have ruled out the FTP server as the issue as I am able to FTP to a totally different set of firewalls so that should rule out t...
Hi all, Not too familiar with cisco wireless yet but I am replacing a 4402 WC that support 25 AP's to a 4402 that supports 50 AP's. I am running 4.1.185 code (upgraded the new one to this code level) and TFTP'd the configuration off the old one to th...
Thank you. You answered my question on how to prioritize the traffic to the primary hub. I wasn't sure if it was feasible to do with ospf broadcast or not so that is greatly appreciated. I was thinking i may have to change the network type to ospf po...
Yes, i am aware that using a DR and BDR will require some design considerations ie keeping the hub (s) as the DR and BDR while ensuring the spokes never take on the role of a DR or BDR. However, given i have one Tunnel interface neighboring up on 10...
Sorry, i failed to mention this. The primary and backup are part of the same dmvpn setup and uses EIGRP currently. The tunnel 251 interface neighbors up on eigrp with the wan block (primary path) and the DR wan (backup) on eigrp using one network 10....
Thanks for all the suggestions. I ended up converting my laptop into a webserver and the file transfer worked to the asa fine but not to the SFR module. I was able to see I/O errors so it ended up being a bad SSD which cisco is replacing.
Hi,
I am just trying to get a file from my ftp server back to the asa. This is the command I am running. it works fine to another set of firewalls fine. I just plugged my laptop/ftp server locally to the management interface and get permission denied...
