Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a quarry that what will happen if we add 1 or 2 physical port in port-channel. However cisco TAC is recommending to bind 4 physical port in port channel, Kindly help me get the clarity on this.
Hi, I am new in redistrution. I have configured the routers. I can see OSPF routes into BGP. However not able to see the BGP router in OSPF as external route. Kindly suggest me how should I configure to get it. Topology: Attached. R1:R1#sh run | s r ...
Hi,
Im new in networking. Im doing a lab where Im trying to see bgp loopback ip ( i.e 3.3.3.3 ) in eigrp. I m not able see.
But while im adding a static route at Null 0 and adding 3.3.3.3 in eigrp network statement then its showing.
in R2 ( whoic...
Hi, Im new in networking. I am getting below information while checking routing entries. Could you please help me what does it mean exactly of below line. Redistributing by eigrp <p.number>, ripadverterised by bgp <ANS>. Waiting to get the reply. Th...
Hi, In the below Diagram. R1 is running RIP. and R2 and R3 are running BGP 23 with R1. I have redistributed between RIP into the BGP. and R4 and R5 are running BGP 45. I can see the 1.1.1.1 route in R4 but unable to ping. Im pasting the diagram and c...
Hi Giuseppe, Thanks for yor comment. That is the reason I have tried to use Prefix-list , then configured the route-map and this route-map added in the interface to get the BGP route in OSPF. Could you please suggest wheather is there any other opti...
