Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I recently updated my Cisco 7940 using firmware P003-8-12-00 for SIP including the SIPDefault.cnf file with correct firmware. But after that whenever the phone boots it looks for several files which are not available. Attached here. Also if I disc...
Hi,
I am facing a strange problem these days. I have a network where PoP-A is connected to PoP-B via a single non-redundant path.
PoP-A has a Cisco 2960G switch with STP enabled. PoP-B has a Cisco SG300 with STP disabled. PoPA to PoPB connected via t...
Hi,
We have a scenario where R1 & R2 are connected with separate physical links (TelCo NLD) with 45 mbps & 100 mbps capacity. We have done iBGP sessions for each of the links both using say ASN 12345. We are publishing 2 X /24 pools using bgp over 10...
Hi,
I had a Cisco 3750E Switch with IP Services Permanent License. I had a version 12 (12.2(55)SE8) in it. We changed it to version 12.2(55)SE11 now. But after version change there is no IP Service License shown.
IP Base is activated as permanent ins...
We have a scenario where R1 running ebgp is connected to different BGP Peers via fa0/1 & fa0/2.
Now my goal is to mark all traffic flowing through fa0/2 with a DSCP mark of 36 for both incoming & outgoing traffic and convey this marking to port fa0/3...
@Dan Lukes wrote:You should read release notes:You cannot upgrade to firmware release 8.1(2)SR2 directly from firmware release 8.0(5) or an earlier release. Upgrade to firmware release 8.1(1) first, then upgrade from release 8.1(1) to release 8.1(2)S...
Hi,I managed to upgrade to P0S3-07-5-00.zip version. But cannot upgrade to latest version -P0S3-8-12-00.zip . When I am trying to do so, I am getting error Upgrade Failed.Any suggestions?
I also didn't want to disable STP but was testing if it works under Non STP mode.
In SG300 - some ports are access directly connected to end users & some are trunk ports connected to APs. From APs end users are connected on VLANs.
I am thinking of re...
Spanning tree details on both switches:
pop a#sh spanning-tree summarySwitch is in pvst modeRoot bridge for: VLAN0101-VLAN0104, VLAN0106, VLAN0110, VLAN0113, VLAN0200 VLAN0202-VLAN0203Extended system ID is enabledPortfast Default is disabledPortFas...
