Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, Currently, Catalyst 1000 Series with version 15.2(7)E not support Flexlink function, but does it support Flexlink+?I've try to add Flexlink+ command on this model not success, the error displayMain port:interface GigabitEthernet1/0/1switchpor...
Hi all,
Please help me to out this issues, Network topology in attachment file.
- Config in FW 5525
object-group network R_SUBNET1 network-object 172.16.41.0 255.255.255.0object-group network R_SUBNET2 network-object 172.16.42.0 255.255.255.0object...
Dear support,
I've bought 3 new switches SG300-10MPP for our Ruckus system. We have Ruckus R710, that can support 802.3at and SG300 can do this too.
But we can't setup this AP run in 802.3at mode, it's only running in 802.3af mode.
In Ruckus Docum...
Dear Support Team,
Please help me to out this confuse.
Does 4500-X series support VDC (Virtual Device Context) function? Our customer want to use 2 Cisco 4500-X for high availability.
- Using VSS function to group 2 physical switch to 1 logical sw...
Hi andrej,
You need config this by manual. Power Negotiation can't established between Ruckus and Cisco SG300
- On Switch:
Try to setup switch advertise all optional TLV via
Administration > Discovery LLDP
LLDP MED Port Settings
Port Settings
-...
Hi Paul,
Thank for you advise. Because this's a urgent case => i try to reboot firewall 5506 and it's working well without any change.
I thinks, there's a bug here.
I'll try to reconfig with your suggest and continue monitoring.
Hi Paul,
1/ Yes, 172.16.42.0/24 interface is up
2/ Yes, in local ASA, i can ping IP 172.16.42.254
3 + 4/ In switch, i have two routes
- route to 172.16.41.0/24 with next-hop ip is Lan's interface Firewall (remote FW)
- route to 172.16.42.0/24 with n...
Hi Mehre,
Try to setup switch advertise all optional TLV via
Administration > Discovery LLDP
LLDP MED Port Settings
Port Settings
And setup Ruckus R710 running POE+ with command: set power-mode at
With all upper config, Ruckus R710 will running ...
In quick start guide, i found switch Cisco SG300-10MPP support 802.3at (Page 6),
http://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/sf30x_sg30x/quick_start/en/300SeriesQSG_EN.pdf
I need advertise all optional TLV on switch and manual setup 8...
