Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I'm currently facing an issue with my Cisco 2911 voice router. The incoming calls for my general line is affected. When the caller calls the general line, the receptionist can hear the ring tone but when off-hook sometimes the calls get conne...
Hi All,
My client is currently intermittent network connectivity issue. And i believe it is due to the IPS. They claimed they have bypassed the IPS module but when I check the configuration, it remain intact on the ASA5. From my understanding, bypa...
Hi All, Appreciate if anyone by chance have this device pack, please share it with me. Urgently needed. cmterm-devicepack9.1.1.21033-4.cop.sgn Thanks in advance.
Hi All, We are planning to move from PRI to SIP link due to cost-saving plan. We are planning to buy Cisco 3945 router for this particular setup. I am not sure about the hardware & license requirement for CUBE. Hoping for inputs from experts here. Is...
Hi All,
I am facing very slow performance from login to toggle between tabs and pages. Attached is the disk usage of the prime. Looks like the opt folder is quite full. Need expertise advise here
Hi @Nithin Eluvathingal,
All the 3 voice ports are configured for the same line and are being used as general line for the office. From VG the general line 0356218000 translated to 18000 and on CUCM we have one extension configured 18000 which the ca...
Hi @Nithin Eluvathingal,
Yes, it's an analog line. The calls land in any one of the three voice ports below but if we bypass the voice gw and plug an analog phone directly into the provider line the incoming calls work fine without any issues.
voice-...
