About kperry

kperry · 10-10-2017

4510 switch with 4 WS-4748-UPOE cards and now 2 of those cards are not granting POE to Cisco 8851 phones. Plenty of power and these cards were granting power and have some phones on them. The issues just seems to be on cards 1 & 4. Cards 2 & 3 will g...

kperry · 10-11-2017

I rebooted the switch after hours last night and the problem showed up again. But this time these two error messages immediately showed up in the log. I did not see these before as they may have occurred weeks or months past as the switch had been up...

kperry · 01-26-2016

According to the 3.7.3 release notes GRE tunnels are now supported on 3850s. http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3850/software/release/3e/release_notes/rn-3dot7e-3850.html Under "Resolved Cavets" - CSCuw19798 GRE Tunnel not wo...

kperry · 02-03-2005

Mark,I am in the process of implementing out of band management of our routers using WIC-1AM cards. Probably what you are wanting to do is use the "service exec-callback" feature. This makes your dial in session look like it is connected to the conso...

kperry · 01-20-2005

I am trying to do the same with a WIC-1AM except using "service exec-callback" which is supposed to only give a console session(no ip routing) to the router. What does your line0/0/0 config look like?

Member Since	‎12-30-2002 09:41 AM
Date Last Visited	‎09-24-2018 07:38 AM
Posts	8
Total Helpful Votes Received	5

User Statistics

User Activity

WS-4748 ports not granting POE power

Re: WS-4748 ports not granting POE power

According to the 3.7.3

Re: Configuring WIC-2AM for Remote Management

Re: call back using modem module