Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi, i want to build a small network with following structure:Internet GatewayNAT Router (Router 1)Layer 3 Switch (Switch 1)vlan 1 to vlan 5Layer 2 Switch (Switch 2)So for testing, i replaced the internet gateway with a normal NAT router (router 0) wi...
hi,
i have a Cisco 867VAE router with ios 15. I want to create 3 subinterfaces for a FastEthernet-Interface, but all my attempts ended in an error message.
xxx(config)#interface FastEthernet 1.1
^
% Invalid input detected ...
Thanks for your reply and sorry for my late answer. I found my fault. I thought that every NAT router is enable to provide NAT feature for multiple subnets, but this is not correct. So i have to replace my Router 1.Regards,Thomas
now i understood you.The bandwidth is around 4 mbit/s, but this doesn't matters, because i would used it for my local network. I know what my fault was, i took the wrong hardware :(.So i will replace it with something with is able to route vlans. Tha...
That's right. Ok, is it possible to implement intervlan routing with subinterfaces on wan-port? What does support for only 2 vlans mean? I can create multiple vlans and assign them to sub-interfaces. So, were is the limitation?
Really? That's bad. I thought this is a default feature for every cisco router. Ok, does this mean, if an interface has only 1 numbered position (like FastEthernet 1), it is only a Layer2-switch, and for interfaces with 2 positions (like FastEthernet...
This will be a difficult task if you don't know anything about networking. Perhaps it is helpful to read some basic information. My knowledge about networks is also limited, but i will tell you what i would do. i assume, that subnet 25 means subnet 2...
