Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I am trying to catch the cause of the high cpu on my cat6500. I run the following eem script which should collect the required information in case of issue
event manager applet High_CPU event snmp oid 1.3.6.1.4.1.9.9.109.1.1.1.1.3.1 get-type e...
Hello
Does anybody know if it possible to increase the default Cisco Fex B22 (HP) HIF buffer-size?
The default one is as follows
Ethernet103/1/5 queuing information: Input buffer allocation: Qos-group: 0 frh: 8 drop-type: drop cos: 0 ...
Hello I am trying to configure basic qos topology with two 6k connected to each other by the trunk port. According to the documentation, if I set the mls qos cos value at the interface level I should modify the default cos on it, and all packets leav...
HelloI am trying to configure an ERSPAN src on the 5k without the L3 daughter card. I try to follow the config guide, but I have a problem with defining the erspan source ip address. The only ip address I have is the ip address of the mgt0 interface ...
HelloI have configured the both client-2-site and site-2-site IPSEC tunnels on my ASR routers. Although I have the keepalive feature enabled on the router, the client-2-site tunnels are not disconnected in case of client to router connectivity breakd...
Hello I have recieved an answer from the TAC regarding my case which might help others having the same issue."To use the CoS value applied with the mls qos cos command as the basis of internal DSCP:-On a port that receives only untagged ingress traff...
Hi Thanks for your reply. I have already opened a TAC case for this problem, and a TAC engineer pointed that I had been missing, the "management" keyword inside the interface vlan configuration. Without it my interface vlan, dedicated for the ERSPAN,...
