Hello
I am trying to configure basic qos topology with two 6k connected to each other by the trunk port.
According to the documentation, if I set the mls qos cos value at the interface level I should modify the default cos on it, and all packets leaving incoming to this port, should be marked with the new cos value.
http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6000-series-switches/24055-173.html
Unfortunately, when I set such config, all incoming packets transmitted through this interface was tagged with cos = 0 until I set the "mls qos trust cos" on the same interface.
Does anybody can explain to me this strange behavior?
I would like to mention that both 6k was connected to each other with ws-x6548-GE-TX modules.
Thank you in advance.
Ragards
Lukas