hi all, I have appliance LMS 4.2, can we save archive config to another storage or  laptop/PC maybe? thanks, ... View more

hi Scott, thanks for your advice, I already  setting what you said, but the connection still slow, I have upgrade IOS too (from 7.3 to 7.4) I have cisco PRIME NCS that reporting Channel utilization every AP on : 1. RF 2,4Ghz (channel 1,6,11) is high (>60%), 2. but on RF 5 Ghz the CU is low (<50%), when the CU on AP low, we have good performance my Tshoot : 1. I change and using channel 3,8,13.. suddenly the CU AP is low (<50%), and we have good performance. 2. there is no issue on this RF my question is : 1. why we get high CU on AP on radio 2,4Ghz? 2. is there any setting on WLC that make CU still low without using non-standart channel ? Thanks in Advance Scott, -- Andrie ... View more

hi Scott, 802.11g still work when disable below 24mbps? wlc automatic setting the power level, can you tell me detail what the affect when use channel 2/3? sorry for too much asking attached show running-config and report too,  thanks in advance ... View more

Hi Scott, thanks for your reply, I followed what you said yesterday, go out and testing. the most users get impact when using 2,4 ghz, but good performance on 5 ghz, after I check the area with software, theres so many interference specially for channel 1,6,11 (cause theres another AP that cannot be shut) so I try to change the channel with channel 2 or 3, and the result is really good the question is? its okay when I used the channel (2,3) ? Thanks in Advance -- Andrie ... View more

hi Scott, do you mean this : i didnt enable yet, is this must enable ? is this affect the parameter shown below : thank in advance,, -- Andrie ... View more

Hi ciscoscott, so, its working if you disabling WMM?, cause I have same problem like this, I have cisco WLC 5508 and 3602 AP configured local and flexconnect mode. please tell me the update.. for the info I limiting the user for radio b/g and a/n is max 24 user, so the AP will accept 48 user right? but if the AP have more than 24 client, the client having bad performance. thanks in advance... -- Andrie ... View more