Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure IP SLA on a 2851 router (source) and a 3750 (stacked) (responder). I have followed the setup instructions in the following documentation.http://www.cisco.com/en/US/docs/ios-xml/ios/ipsla/configuration/15-0m/Configuring_Cisco...
Have a really simple question I know it is possible to put multiple IPs' on the outside interface of the PIX, will the standard ip address outside XXX.XXX.XXX.XXX XXX.XXX.XXX command work? And if I use that will it erase the ip address I already have...
I need to set up a static NAT for a surveillance camera on our network, so that it can be viewed as a demo to some people. camera ip: 10.8.xx.xxx 255.255.255.0public ip: 64.207.xx.xxx I have just started dealing with a PIX so any help would be app...
I have a group of users set up for VPN they can connect into the network without any issue, but while connect with the VPN they cannot access the web. They are part of the same vpn pool as another group and that group doesn't have a problem, but the...
I need to allow traffic in and out through port 5003 for a couple of credit card machines we have. I created the access-list below access-list test2 permit tcp any host xx.xxx.xx.xxx eq 50003It still will not allow it to connect to the credit card c...
Ok, I setup the static statement, but I don't think it worked because I tried to ping that public IP and I got nothing. Do I need to add an access-list to allowing traffic to it?
Yes the camera is on the inside of the PIX. Ok, I am fine with setting up the NAT for the camera that doesn't seem to be too hard. For the acl would the below do? Also, do I need to add the new public IP to outside interface, basically do I need to...
We are using the 7941 series. I did the reset and it worked just fine. However, the time is off by like 15 mins. You wouldn't happen to know how to fix that?
