Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Jsut curious if anybody has seen this. I have 4 Metro Ethernet switches. I have access to these switches from a network monitor for backups . However one switch is not working. I can ping it from the local switch it is directly connected to, but not ...
I am trying to determine the best option for Implementing spanning tree on Metro Ethernet. Essentially I need each customer bridge-domain/vlan to be in its own instance. A few people have recomended using MST. My question is why? If each customer is ...
I am having a spanning tree issue between 2 switches. Each port is setup as a basic trunk, and the 2 ports are connected over a microwave link. Spanning tree is setup as MST with 4 instances, and I dont have this problem anywhere else. Lopguard defa...
I have dynamic ipsec VPN setup between a 5505 asa that has a dynamic ip address on the outside, and a 5520 that has a static address. When I setup the tunnel on the 5505 it comes up and works fine. However, if the ASA or the Modem supplying its IP ad...
I have an ASA interface in which Proxy Arp is still enabled for some reason. If I turn this off for this interface, will there be any type of down time for resources or blips when this is done?
Ok, I think we are just on 2 different pages. For example, if you are trying to access it from another network, it may lost its gateway configuration. So, the access request may get to it but it dont know who to reply, just to list one possibility h...
Yes, I understand how to access a device remotely. Your statement "In your case where the switch respond to ping" is not accurate. Please read my original question. What I am trying to figure out is why this particular device I cannot access remotel...
I don't believe that to be accurate. There has to be a reason remote access isnt working. It works on all the others. Just has to be something I am missing.
No they do not. Thats untimately what I am trying to figure out. Why can't I access this switches from remote. It has the same basic config as my other ME3800s that I can reach from remote.
