Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,For last month, we are facing issue with our switch network, previously it was stable and working fine.We have total 8 Cisco SG500 (Qty-1) and SG300 (Qty-7) series switches in our network.To troubleshoot the issue, today we scanned the...
Hello everyone,We had configured stack of 5 Cisco 9200 series switches.We arranged all 5 switches according to lowest to highest MAC address in the stack.1) SW1- C9200-48T-4G-E -- MAC- 24:2A:04:F6:F4:00 (Active)2) SW2- C9200-48T-4G-E -- MAC- F4:EE:31...
Hello everyone,We have Cisco SG500 switch and we have configured it as inter-vlan router.Multiple VLANs (total-10) have been created and for it multiple VLAN interface have been created.Port G23, G24, G25 & G26 are connected to another switches so th...
Hello everyone,We have Cisco SG500 switch and we have configured it as inter-vlan router.Multiple VLANs (total-10) have been created and for it multiple VLAN interface have been created.Port G23, G24, G25 & G26 are connected to another switches so th...
Hello,We have 2 Cisco SG500 switches in the stack, on which we created VLAN 2 to VLAN 9. We enabled GVRP globally and also at interface level, configured ports as trunk port (G1/1/23 and G1/1/24).Firmware version is 1.4.11.2.On both the ports, we con...
Hello,I tried following things:1. Remove the power cable.2. Remove the stack cables (not stack modules).3. Connect console cable to that switch (SW2)4. Again power on the switch and connect it console.And got the output, kindly check the attached ima...
Hello sir,We have Cisco SG300 series switches in the same network, some netgear switches are also conencted to these SG300 switches.But on SG300 switches, default port status is ACCESS, so we configured "Switchport mode trunk" command for manual trun...
