The new Cisco RV160 router allows VLANs to be configured with different subnet masks. I have 2 VLANs (VLAN 1 and 18) with networks defined as follows: VLAN 1 -- IP: 192.168.2.1/255.255.255.0 (24) (ports 1, 2, & 3)VLAN 18 -- IP: 198.18.64.1/255.255.0....

Site has multiple WAP571 access points (5 total) deployed each connected to a 2960X-24S-L switch. The WAP571 devices are the only devices connected to the 2960X. The WAP571 devices are all running the latest firmware -- 1.0.1.10. The 2960X is running...

I have an installation using several 2960-X switches in a stacked configuration. Due to wiring restrictions, one of the 2960-X switch ports is connected to a 5-port Cisco non-managed switch in a remote location that serves several devices. When conne...

I have four 2960-X switches that will be stacked. Before creating the stack, I ran Express Setup on all switches assigning them each a unique IP address. I then connected the switches to my existing network and used Network Assistant to load the most...